Xds 510 device driver

My problem is that I can't seem to figure out which drivers to install, since there are about 3 different drivers on the CD-R. If I knew for sure who made this hardware, and which driver was appropriate, then I'd probably be able to get it working.

Last year, I struggled with strange error messages and was working with an unproven TMS board of my own design, but eventually got it working. If only I had realized that I would of course forget which driver and settings worked, then I would have taken careful notes.

Obviously, narrowing down the possibilities by removing variables is going to be key. I still have the old boards, though, if that turns out to be the issue. This product sounds like it could be a a cloned XDS Many of the products on ebay are clones of legitamate XDS vendors. You should contact your vendor and get updated drivers.

Thanks for the reply. I was afraid this might be a clone. Seeing the TI logo on a box that doesn't come from TI is a bad sign unless all of the third-party emulators have the TI logo.

There is no vendor, though, since this was basically an individual to individual eBay purchase. I'll try to find out whether the seller is still available on eBay and speaks English or we can find a translator. Much of the documentation was in Chinese, but otherwise looks identical to TI documentation. If only the price difference were not a couple of orders of magnitude more, then this cloning would be less of an issue.

Sorry for the rant. I'll see what I can find out from the source. EWA ". I think that is Blackhawk. That is what my Virtual Machine sees it as when I connect my Blackhawk emulator to it. Thanks Brian. We've been working to get prices down, and XDS is one of the ways. Though not that fast, we have tried to make sure XDS is very stable, so I would like to understand what kind of instability you are seeing.

However, if I need to pause, recompile, download the new firmware and run, there's a high probability that CCS will crash or freeze. The more times I repeat the cycle, the more likely it is to wedge. If I disconnect, power-cycle my board, then reconnect for firmware download and execution, then it seems to help a little, slightly reducing the chances of a problem. Even with power-cycling, I still eventually get a freeze or crash.

I'm running the latest CCSv4 version. But that is not always a solution, either. Technically, my board at that time was missing one or two pull-ups, which I have added on the revised board.

I hope that adding the recommended pull-ups did not actually cause any problems. Did You try with the original BlackHawk drivers this product? I do not think that chinese people did anything else that a perfect copy of a well know emulator Aniway, If you can configure it under CCS4 please let me know.

A related question is a question created from another question. When the related question is created, it will be automatically linked to the original question. Ask a new question Ask a new question Cancel. Tags More Cancel. Share More Cancel. Similar topics. This thread has been locked. Genius points.

This happens on different EVMs. When using the XDS onboard emulator it works fine. When i run the Reset Emulator. Hope you can help me out. Alter over 11 years ago. Anders, Have you run the SDConfig utility? Run the SDConfig utility and make sure the emulator driver is setup correctly. Regards, David. Up 0 Down Cancel. The version of the emulator is Rev A.

I have tryed using the SDConfigEx tool and this is what i got:. Alter over 11 years ago in reply to Anders Lange. Hi David. Here is what i got from the SDConfigEx:. Anders, Is the emulator known good? Regards Anders. Prodigy points. Regards Roger. Expert points.

We get this error : The controller has detected a target power loss. This answred is verified. Please verify these answer to close this thread. Think you!!